Mike Alex

New Member
Dec 21, 2021
25
5
3
Ho Chi Minh City, Vietnam
If you download this document, you will be lost Beer
Download Now
Programming EPS Control Module of the BMW 520i 2013
Programming Process:
Step 1:
Connect the software to the car and select to the EPS system and select Display fault memory to check for errors.

1675218399793.png
1675218425595.png
Step 2: Select Vehicle management -> Control Unit Replacement -> After Replacement. Select electromechanical power steering system and select Display measures plan to go to the next step.

1675218469742.png

Select "Calculate measures plan" to continue the process.

1675218516905.png

Select "Execute measures plan" to continue the process.

1675218556176.png

The message appears to turn off all the loads on the car and click "Continue" to continue the process

1675218601894.png

The message appears the conditions to be prepared to perform the Programming carefully reads the notification and checks the condition of the vehicle and presses "Continue" to continue the process.

1675218634926.png

The software is performing the installation process

1675218669559.png
1675218705260.png

Programming process completed

Step 3:
Perform the "Tech-in end stop" process. Select EPS: Tech-in end stop -> Execute service function.

1675218744474.png

Select "Continue" to continue the process

1675218772773.png

Message "The software end stops of the electromechanical power steering are correctly taught-in. No further measure must be performed" the End-stop position has been learned correctly and no further measurement is required. Select "No, do not perform a new teach-in process" and click Continue to finish the process.

1675218922291.png

GOOD LUCK!!!

 
Top Bottom