Scania SDP3 (Diagnos & Programmer 3) 2.40.1

[ohenry]

If you download this document, you will be lost 1605 Beer

Scania SDP3 (Diagnos & Programmer 3) 2.40.1​

Description
SDP3 (Scania Diagnos Programmer) communicates with Scania vehicles and Scania industrial and marine engines. The program is designed to ensure the operation of the electrical system in the CAN network. The program is used for troubleshooting, setting parameters preferred by the client, performing calibrations, performing upgrades that affect the electrical system, and updating the software of the control units.

Capacity: 890 MB

Region: All region

Language: Multilanguage

Computer Requirements:
Free drive space: 15 GB or more
CPU: Core i3 or above
RAM: 4 GB or more
Operating System: Windows: 7 32/ 64 Bit

Software Feature:

• Read & Clear Diagnostic Trouble Codes (DTCs)
• Data List
• Activate test
• Programing ECU
• Wiring Diagram
• Component location
• Built-In Help & Troubleshooting
• Update ECU
• Parameter Calibration

Some interesting options:

• AdBlue ON/OFF.
• EGR ON/OFF.
• Chassis ID/VIN Change.
• Immobilizer ON/OFF.
• Truck Power INCREASE.
• ECU Recovery.
• ECU Reset.
• ECU Unlock

Supported models:

• Truck & Heavy Truck
• Bus
• Scania industrial and marine engines

System support:

• EMS – Engine management system.
• GMS – Gearbox management system.
• RET – Retarder system.
• AWD – All wheel drive system.
• CLS – Clutch Control.
• EEC – Exhaust Emission Control.
• COO (COO7) – Coordinator.
• BWS (BCI1) – Bodywork system

Supported Hardware​

• VCI 2
• VCI 3

Our policies and instructions: https://dhtauto.com/dht/threads/rules-when-using-the-forum-update-to-03-01-2022.90280/

Our channels: https://www.youtube.com/channel/UC4jMJIFZsycq2qddyxcxIpg/